|
Rolflor™
Cargo Handling System
Features and Benefits
 |
Front
and Rear Drive Stations
Rugged
welded steel enclosures house the front
and rear drive subassemblies, which contain
powerful high torque transmissions. |
| |
|
 |
Belt
Bulkhead (optional)
The bulkhead, a moving wall attached to the
front end of the belt, pushes and entire load
onto the dock. |
| |
|
 |
Belt
System
Unique fiber-reinforced belt is less than
3/16" thick. Upper (load) surface is
coated with special resin that is resistant
to cuts and abrasion, and has a high coefficient
of friction against a wood pallet. Lower surface
is a tough polyester fabric, impregnated with
a wear and chemical resistant resin, and has
a low coefficient of friction against floors.
|
| |
|
 |
Trailer-Mounted
Electro/Hydraulic Power Pack
(optional)
Pump/Motor Set and 20 gallon reservoir with
filter/breather, level/temp gauge and clean-out
door. Totally enclosed fan-cooled electrical
motor is close-coupled to the pump. Power
pack is externally mounted for easy routine
maintenance. Gas and PTO driven power packs
also available. Control panel includes multi-pin
power plug, forward, reverse and belt travel
limit relays. Directional valve, pressure
gauge, filter and relief valve. Can operate
from tractor or dock power. |
| |
|
 |
Anti-Friction
Floor Plates (optional)
The Rolflor belt lies directly on the trailer
floor, and uses no rollers or other support,
Anti-friction floor plates can be used to
further minimize coefficient of friction. |
|
|
Rolflor
Images -
click an image to enlarge.
| |
|
|
| |
|
|
| |
The
standard Rolflor design fits a 45,
48, or 53 foot, 102-inch-wide trailer
and will move loads in or out at
15 feet per minute nominal speed.
Installed in a new or existing trailer,
the system can pull in or push out
loads of up to 30,000 or 55,000
pounds.
Contact
Us to learn more about Rolflor. |
|
|
|
|
|
